Hi,
I want to change all my front lights to LED. I've read that many owners have used Techmax H11 LED https://www.amazon.co.uk/TECHMAX-Headli ... ds=h11+led
Will I need 2 kits? One for DRL/Fog lights and one for High Beam?
Thank you very much in advance!
Front Lights change to LED
You will need one set for the highbeams and one set for the fog lights.
The DRL bulbs are known as H16 or 5202 bulbs
You can install LED H16 or 5202 bulbs to really improve the look of the car from the front.
These are ones I would recommend you go for: https://www.amazon.co.uk/KaTur-Bright-D ... words=5202
The DRL bulbs are known as H16 or 5202 bulbs
You can install LED H16 or 5202 bulbs to really improve the look of the car from the front.
These are ones I would recommend you go for: https://www.amazon.co.uk/KaTur-Bright-D ... words=5202
They are LED from the factory on the N-Tec and abovekapnos wrote:Thanks for the reply.
And what about the dip beam?
You will have to get some brighter halogen bulbs then otherwise if you install LED's you will blind oncoming drivers.kapnos wrote:I have 1.5dci accenta.
-
- Posts: 44
- Joined: Sun Nov 19, 2017 4:26 pm
You could always fit HIDs providing there is bulb space etc?
Getting my 64 Pulsar at the end of the week. Didn't take notice what lights were on a Tekna but my test drive pics show those gawd awful halogen fellas. Is there a trap door in behind the bumper/wheel arch or is it awkward to get that panel off Rich?
Thanks and good luck.
Getting my 64 Pulsar at the end of the week. Didn't take notice what lights were on a Tekna but my test drive pics show those gawd awful halogen fellas. Is there a trap door in behind the bumper/wheel arch or is it awkward to get that panel off Rich?
Thanks and good luck.
2014 1.2 Dig-t Tekna
Steelmate reverse sensors
LED full beams
Steelmate reverse sensors
LED full beams