Hi I wanted to replace my reverse lights today to some leds I ordered, only problem is that I can't take the back lights off. Looks very simple on the manual, take the two screws out and should pop out but it doesn't, feels like there's another screw holding it but can't seem to find it.
Was wondering if anyone has taken em out before and how they managed it. Thanks.
Rear light Housing
There isn't another screw.
Remove the two 10mm bolts.
Then you have to grab the light and pull towards you.
You have to give it a good tug!
Remove the two 10mm bolts.
Then you have to grab the light and pull towards you.
You have to give it a good tug!
Damn I thought I was going to break it, it's abit stiff isn't it, hard to remove but thanks, I'll give it another go latermrrichmond1995 wrote:There isn't another screw.
Remove the two 10mm bolts.
Then you have to grab the light and pull towards you.
You have to give it a good tug!
-
- Posts: 48
- Joined: Thu Jul 21, 2016 10:00 pm
and now you'll say 'it just come off in your hand' !!
-
- Posts: 44
- Joined: Sun Nov 19, 2017 4:26 pm
After changing my rears, I noticed I scratched the paint around the edges of both the clusters. USE MASKING TAPE around the edges of the paintwork or lights when you do it!!
Also, use a pair of grippy rubber style gloves to assist with the power/adhesion.
Also, use a pair of grippy rubber style gloves to assist with the power/adhesion.
2014 1.2 Dig-t Tekna
Steelmate reverse sensors
LED full beams
Steelmate reverse sensors
LED full beams