steering wheel controls

[manospace]

hello, I bought a 10 inch android , but I would like to connect the steering wheel controls what do you recommend and how to install it?

[Bleubolt]

Here the low.down, I got android unit. Messed around a bit got passed of etc. Returned it, found f a cheaper one to mess.around with and it's all.working, even steering wheel controls.

Get this crappy harness, and use the main 32 pin one and the one with 4 green wires. (Plug that into the other nissan block) and it works, set the android up as Raise canbus, nissan, pulsar the only thing I get is the skip forward and back are around the wrong way but whatever. It works no chopping up wires or anything.

Just found this amazing item on AliExpress. Check it out!
￡13.75 | CAN Bus Decoder Harness Wiring Adapter 16 Pin Connector Radio Antenna Cable for Nissan Qashqai J11 Tiida Sentra X-trail Teana
https://a.aliexpress.com/_Eyt3dwf

And just connect the 2 blocks as above plus the grey aerial . Also get.one of these USB adaptors from ebay for 3 quid

USB 2.0 type A Male to Mini 5-Pin USB Female Connector Adapter convertor UK

For the arm rest.usb socket.

[Bleubolt]

You ebmven get the file name in the instrument panel

[Bleubolt]

I would say this had unit is damn slow, I only got it for the android auto, which is quick. But got for a unit with 4gb ram minimum.

Plus ebay had a 20% off deal or something.

[Bleubolt]

And for the dash Clock, after searching, sostenuto you can assist the time without the head unit from some info I read on quasquai forum


On the steering wheel, hold ENTER for 8 seconds. If successful, the dashboard monitor should now read "Set Time". Use << SKIP >> to do this. Press Enter again to save the time

[Bleubolt]

And make sure you keep the airbag lead plugged in if you turn on ignition to avoid the airbag warning light staying on

[borraw]

Is there a chance that the original 360 degree view will work with this Сanbus decoder?